Thread: Tank Guards
View Single Post
Old 12-30-2005, 05:14 PM   #12
mars
Starbucks anyone?
 
mars's Avatar
 
Joined: Jun 2002
Location: El Reno,ok
Oddometer: 1,896
Quote:
Originally Posted by Loadedagain
as i mentioned above i would stay clear of the petcock protection unless you can figure a way of maybe building out in front of it without impeding easy access.

for most of my layups i use west systems epoxy resin. you may want to try them out. very nice stuff. i've always used their slow hardener since time of cure is not a concern and the extra time to layup is nice. their web site: http://www.westsystem.com/

often the fibre material you use is not as critical as the matrix. for example i would stay clear of polyesters... especially with hand layups. they cure very quickly, and you will likely have too much matrix for the amount of fibre. if you are using a polyester i'd set it off real cool, and vacuum bag the bitch!

probably the best way to do guards at home is with about a dozen layers of carbon, maybe a few kevlar outer layers for abrasion, use an epoxy like west system, and vacuum bag it. you will end up with a real nice part.

if you don't have a vacuum pump you can rifle through the junk yard for an old fridge and steal the compressor outa it. makes for a really great little vac unit.
i want a set without the petcock protection. i did talk with a friend in Boise that droped his 02 from a standstill and broke the tank. the cross bar that holds the rubber front mounts went right through the side with a moderate lateral impact.
mars is offline   Reply With Quote