View Single Post
Old 07-02-2013, 07:29 AM   #17
Vassily28
TheFrenchCanadian
 
Joined: May 2008
Location: Quebec
Oddometer: 320
[QUOTE=crazybrit;21740445]Did you make the copper sheet heatsink on page 8 of the manual? I assume you didn't try the heatsink Innovate sells (see below)?

So the old link was not working anymore so:
http://www.ridaventure.ca/index.php?...1/page__st__40

And yep, after fist error codes i've tried the heatsink sold by innovate and it didn't change the over all results. The results was the same error codes. It happened a bit later than previous but still results in impossibility of recording a complet log for the rear cylinder. Like said before, it's probably cause of the proximity with thecylinder and a temperature too high for the probe.

Oh, if you try the heatsink by innovate, don't forget to use a "never sized" stuff cause it is in SS. Dont ask me why, but i know have a M18 tap im my tool box.
Vassily28 is offline   Reply With Quote