Originally Posted by gozirra
What material did you use for this?
I used this stuff: http://www.amazon.com/gp/product/B00...?ie=UTF8&psc=1
There are cheaper options, but I liked how thin it is. Plus, fitting it was a PIA and I figured the extra cash was worth [hopefully] not having to do it again.
I also shielded the inner side of the pump housing and had plenty left over, just in case. Smaller sheets are available, but I needed this in a hurry and that was the only size I could get in time.
Haven't had chance to see if it cures the issue yet, but so far I'm pleased with the way it adhered (all I did was clean and degrease the area prior to application) and am hopeful it will at least help delay things. If it doesn't, it could be time for a second fan and low temp thermostat switch, I guess...