View Single Post
Old 07-12-2013, 02:53 PM   #5
baachor OP
Adventurer
 
Joined: Jun 2013
Location: Costa Mesa,CA
Oddometer: 65
Hi Sintax,

I'm going to clean all right now. I did valves yesterday again and seems like one of exhaust valves were too tight with no free play.FIxed that.Going to check it again just in case.And will post all details you wanted.

Quote:
Originally Posted by sintax View Post
After having my XR for a few years I'll start this one off...

Any new XR should have the following done.

1) check and adjust valves
2) detail strip and clean the carb thoroughly. Ensure all jets are clean, ALL passages clear. Measure float level, adjust if necessary. Record all jet and needle settings.

Once the above had been done report back and we can talk. It's a big crap shoot until the above is done.

Best of luck
I don't know what that means.Sorry I'm new at R.

Quote:
Originally Posted by sintax View Post
Oh and also confirm if you are running the restricted carb manifold...
baachor is offline   Reply With Quote