View Single Post
Old 07-13-2013, 03:53 PM   #8438
Nixels
Face fears - live life
 
Nixels's Avatar
 
Joined: Sep 2006
Location: West Oakland, CA
Oddometer: 7,692
Stator wiring question



I finally got a stator for my '88 XR600R.

Less than 90 days after getting the bike!

I bought the RickyStator unit and am trying to install/plug it in today.

The challenge for an electronics-challenged guy like me is that I don't know how to convert/interpret what I see to make the switch from old to new.



This bike has a battery & all the lights. So I think it should be dual output 100watts each.

That would suggest I use the wiring diagram on the upper left.

What I can't figure out is how to relate the green/white pairs to the original pairs in the 4-plug connector. How do I work that out? I have a digital multimeter that I could use to assist me - if I knew what I was trying to do. s

And once I figure that out, do I:

Cut the old connector off and add it to the new wiring harness?

Or

Cut the old connector off the wiring harness and add the four individual connectors to the wiring harness.
__________________
Coffee first, then all your other mundane bullshit. Benjava

SmugMug coupon: cwbkgu7KGL2D2/save $5
Nixels is offline   Reply With Quote