View Single Post
Old 07-13-2013, 06:08 PM   #4249
Vico1
The Maestro
 
Vico1's Avatar
 
Joined: Oct 2008
Location: Ft Walton Beach FL
Oddometer: 5,817
Air Guy ??

Quote:
Originally Posted by Capp View Post
CS torque is 60nm/44lb ft of torque. Primary gear is not the CS.
I have an air compressor and for many years have simply used my impact driver to quickly spin off the Front Sprocket retainer bolt and washer. I change front sprockets often and especially on my 500. Make sure new sprocket and washer are properly aligned (yes you can screw this up) and hammer away until I hear the sound change. I have no clue what the actual torque is.

Not that I am going to change after 40 years but other than the obvious "over-torque induced metal failure" why is this a bad thing
__________________
KTM 500 EXC Yellow Vee Black DR650
A few others in the past

You dont quit riding when you get old, you get old when you quit riding.
I don't always ride street bikes, but when I do I prefer VStroms
Vico1 is offline   Reply With Quote