View Single Post
Old 08-12-2013, 08:45 PM   #22
CPRFAB
Gnarly Adventurer
 
CPRFAB's Avatar
 
Joined: Feb 2012
Oddometer: 206
Quote:
Originally Posted by timbo45 View Post
Im doing the filter and the canostraphy but I cant find the plug with the resister in it where can I get this plug
so the FI light wont come on.
A 1000 ohm 1/4 watt resistor is commonly used and available at electronics stores (Radio Shack). Remove the plug from the removed SAS valve and cut one of the wires 1" (25 mm) from the back of the plug and the other about 2 so they are staggered. Solder the ends of the resistor to each wire keeping the ends of the resistor longitudinal with the wires so that they are in a tight package that you can slide a piece of heat shrink over. Shrink the shrink and plug it in. No FI light.
__________________
www.rottweilerperformance.com
Rottweiler Performance FB page
"They can only copy where we've been"
Original designs. Proven quality. Rottweiler Performance.
CPRFAB is offline   Reply With Quote