View Single Post
Old 08-14-2013, 04:44 PM   #34
flynride
Gnarly Adventurer
 
Joined: May 2007
Location: Irvine
Oddometer: 125
Quote:
Originally Posted by CMurgel View Post
Can you tell me what you had to do to install it?

If you can post a list of modifications and how much did you spent I would appreciate!
It is not hard to install if you are mechanically inclined. Check out their website and go to the downloads page. Then on the bottom right of that page, there is a few manuals for installing the system on your bike. you don't need to modify anything really.

http://www.rottweilerperformance.com/

Total cost was about $350 for the intake kit and the SAS block off plates. Then you will need to load a mew map into your bike depending on other mods. I'm also running the pre filter because I am mostly in the dirt.

If you are looking for more power and a better running bike, get the intake...you will be stoked.
__________________
2013 990 ADV
2001 996S
flynride is offline   Reply With Quote