View Single Post
Old 08-31-2013, 09:15 AM   #54
disston's Avatar
Joined: Mar 2011
Location: Silver Spring, Md
Oddometer: 10,012
Originally Posted by Lornce View Post
I don't believe this is accurate.

I've mated turned Nik barrels to /5 cases without clearance issues.

Maybe it's not the /5 that hits the spigot. I've never done it. The issue is that some cranks hit the spigot. Check the fit of the cylinder you have against the crank in the block you have. Rotate the crank. If it hits you have to spend some time grinding.
Never memorize something you can look up.
---Albert Einstein

Pay your debt, piratejohn.
disston is offline   Reply With Quote