View Single Post
Old 09-15-2013, 04:27 PM   #1533
640 Armageddon
640 Armageddon's Avatar
Joined: Mar 2009
Location: Greece
Oddometer: 2,843
And back to the towers again...

Below is the back plate that is a straight bolton to the KTM690/450RFR's for the Mk1 RB holder. Managed to make it from a 3mm aluminium, hard anodised it black an its performance will be tested on Friday when the Australasian Safari begins
It follows the RB profile. The only difficulty was to ensure that the top part matches the two factory side plates.

At this point Pete640 and MakS provided all the help I was needed to make the plate. I would like to thank them both for their help and I hope that I can return the favour in the near future

I was worried about the side web welding, so we welded both sides of the webs. There is also intermittent welding behind the sheet bends in order to ensure that if any cracks decide to initiate at that point, there will not be a catastrophic failure

Aurora Rally Equipment - Rally parts with lifetime warranty
"Do or Do Not. There is No Try" - Yoda
640 Armageddon is offline   Reply With Quote