View Single Post
Old 09-15-2013, 07:09 PM   #1534
HalfFastMoto
bRad
 
HalfFastMoto's Avatar
 
Joined: Mar 2007
Location: Bothell, WA
Oddometer: 1,152
Thumb

Quote:
Originally Posted by 640 Armageddon View Post
And back to the towers again...

Below is the back plate that is a straight bolton to the KTM690/450RFR's for the Mk1 RB holder. Managed to make it from a 3mm aluminium, hard anodised it black an its performance will be tested on Friday when the Australasian Safari begins
It follows the RB profile. The only difficulty was to ensure that the top part matches the two factory side plates.

At this point Pete640 and MakS provided all the help I was needed to make the plate. I would like to thank them both for their help and I hope that I can return the favour in the near future

I was worried about the side web welding, so we welded both sides of the webs. There is also intermittent welding behind the sheet bends in order to ensure that if any cracks decide to initiate at that point, there will not be a catastrophic failure


This looks very stout!
__________________
-bRad
08 KTM 990 Adv S
08 Honda CRF450X-SM
12 Christini 450 Rally Lite
13 Christini 300 E
HalfFastMoto is offline   Reply With Quote