Anyone else here having unstable idle issue with #45 jets ?
My bike runs well when cold but when it warms up well in a warm day, idle goes up to 2000rpm or so or comes down bellow 1400. Its impossible to keep it at 1400.
I checked the float levels as it was suggested here (see my original post:http://advrider.com/forums/showthrea...4#post21920674
) . They were a bit off, I set them to exactly 4mm. It got better but still not stable.
I had this issue couple of years ago with H2W jet kit when I put #45 jets in. I replaced it with stock 42 and it became OK. But 45 is recommended here.
I also have lots of popping on deceleration.
Here is my setup :
Factory pro Ti needles on 3rd clip
Floats at 4mm
FMF pipes, SAS removed.
Have FlexJet IMS