View Single Post
Old 10-09-2013, 10:13 AM   #2434
Ravenslair
Gnarly Adventurer
 
Joined: Feb 2012
Location: Placer County, California
Oddometer: 430
Quote:
Originally Posted by ACD View Post
That plate looks very professional!! I wish my home made improvements looked half as good as yours :)

Sent from my iPad using Tapatalk - now Free
Thanks, I appreciate that. Took a few metal jigsaw blades. Should have just used a carbide blade on my Skilsaw.


Quote:
Originally Posted by SylvainB View Post
Nice job, I'm planning to do the same, can you show the other side of the skid plate so the attachements are visible? What did you use to attach the plate? Did you use rubber inserts? Thanks
Thanks.

I will take a picture when I get home tonight. I used 1" Hillman Group steel clamps (from Lowes in their hardware section, likely the same for any other big box hardware store). The lower set of holes were drilled incorrectly. Measure twice, cut/drill once. I broke that rule this time.
Ravenslair is offline   Reply With Quote