View Single Post
Old 10-17-2013, 01:37 PM   #33
BigTony
Gnarly Adventurer
 
Joined: Apr 2011
Oddometer: 182
Quote:
Originally Posted by veesquared View Post
When my allens show a little wear i will use air cutoff wheel and remove the worn area.I use an angle air sander and take off any burrs and make sure the end is flat. Try a very small dab of valve grinding paste on the end of the allen. Clean bolt head before re- stalling.
Good tip here - I think I my tools may be due for this treatment
BigTony is offline   Reply With Quote