View Single Post
Old 10-22-2013, 02:24 PM   #72
vegemanNZ
Adventurer
 
Joined: May 2010
Location: Wellington, NZ
Oddometer: 50
Using Rox anti-vibe risers as well.

Hi,
I have standard bar clamps with rox anti-vibe risers. the height above standard must be at least 2" which works well for me and also works with the cables etc.

With the risers there is plenty of room for the scott damper to fit underneath but I would need a very thin triple mount/bracket so as not add extra height to the bars.

BAsically, I don't want to get rid of the rox units yet...so am looking for a real low profile plate. Rbott's nicely machine block seems like the one, and the lowest height is 1"...but as mentioned, that would still add too much height overall.

I was wondering if I could use the rbott 1" mount, and then cut down the standard bar clamps by 1" meaning the overall heught remains the same OR perhaps recess the mount to accept the standard risers.

The other option I guess is to get rid of the rox risers...but I like them.

Thoughts?
__________________
2008 KTM 690E - Adventurotard - forget dual sport, get triple sport!~
vegemanNZ is offline   Reply With Quote