View Single Post
Old 01-06-2014, 11:43 AM   #23
igrek
Adventurer
 
Joined: Mar 2013
Location: Poland
Oddometer: 12
Quote:
Originally Posted by Aasdasdasddd View Post
I've disassembled my fork and measured the parts mentioned above. For 2012 990 adventure R I need only these parts:
48600380S1 --- HYDR.STOP L=200MM D=31,9 CPL
48600226 --- 420mm Cartridge Tube(inner tube)
Ktmtwins responded to my previous questions about the kit - the springs are .48 nm(stock for 950s) rate - which is too little for me.
Yep i did it myself with my 04 950 , exactly same parts in front.
I bought .62 kg/mm springs from slevens racing.
The length of the springs stays the same.

For heavier springs you must grind some material from hydro stop part in order to put the springs on

The rear needs more attention, one part is needed , thinner rebound shim but what about the spring, You must buy 265 spring or make a spacer or use additional spacers
50180114, one is almost 1,5mm thick.

Then you need suspension service to put oil, pull air out and fill gas.
igrek is offline   Reply With Quote