View Single Post
Old 01-16-2014, 03:27 PM   #3
Gnarly Adventurer
chief_lee_visceral's Avatar
Joined: Mar 2010
Location: Seattle
Oddometer: 402
Originally Posted by gozer View Post
Sorry if this is covered in another thread...I spent a bunch of time searching, but couldn't find anything.

I'm removing the foot pegs to install the touratech skid plate. The left hand side comes of easy enough, but the pin for the right hand side is blocked by the brake pedal.

Am I being an idiot? Or do I have to remove the brake pedal to get it off? (the answer is probably both).

Just remove the bolt into the master cylinder plunger. That will give you enough room. It is advised to use thread lock on all brake parts when you put it back in.
-= Never put your finger where you wouldn't put your face =-.
chief_lee_visceral is offline   Reply With Quote