View Single Post
Old 01-17-2014, 10:41 PM   #3
Studly Adventurer
Katoom72's Avatar
Joined: Jun 2012
Location: Belgium
Oddometer: 917
according to manual: Set the rear to TDC and check for the position notch (locking bolt notch) on the crankshaft. If the notch is visible the rear cylinder is at the right mark to put the cams in.
The markings of the crankshaft and idler gear should line-up as well.
'03 KTM 250sx -- '05 KTM Adventure 950
'00 KTM 250sx -- '03 KTM 450sx -- '03 Yamaha R6 -- '08 KTM SuperDuke R --- '13 KTM 690 enduro R
Katoom72 is offline   Reply With Quote