View Single Post
Old 01-27-2014, 09:06 AM   #40
przjohn OP
Adventurer
 
Joined: Aug 2008
Location: Ellington, CT
Oddometer: 89
The next job that was to be tackled was the seat.


[/IMG]

But then there was this surprise. The seat pan is N/G. I have ordered a new reproduction one from Z1 Enterprises.


[/IMG]


So, it was move on to the front pegs.


[/IMG]


The springs, washers, and clips were all run through the Zinc plate process.

[/IMG]


Then attached to the freshly painted stalks with new reproduction grips.


[/IMG]
przjohn is offline   Reply With Quote