View Single Post
Old 01-27-2014, 03:49 PM   #61
PNWRider
Live an Adventure!
 
Joined: Sep 2007
Location: Yamhill, OR
Oddometer: 27
For Yamaha Super Tenere

I have been following this and your other threads, I think I am going to get some of your long range extreme LEDs but I am also intrigued with these.

The Super Tenere uses 2 H7 bulbs, but the back of the headlight housings are sealed with plastic plugs and o-rings. It looks like there is only about a half an inch between the end of the plug on the light and the plastic cap when it is closed. I assume that the H7 LED protrudes the same amount as the one you show in post 1.

If this is the case is there a future possibility of making the electronics a separate unit that can be mounted outside of the housing or is this needed to help cool the LED itself?

Have you ran into this with other bikes?

-Ryan
PNWRider is offline   Reply With Quote