View Single Post
Old 01-29-2014, 07:52 PM   #178
jlw
Adventurer
 
Joined: Oct 2010
Location: Niagara, Ontario
Oddometer: 16
new producer

I would like to have a compact block and tackle just like the ones formerly produced by Adventure Engineering.

I might be able to get a local machinist to do a run of them. I was thinking UHMW spool on a stainless shaft in a aluminum house. I would use
7/64" Amsteel spec'd at 1400 lbs minimum strength.

No doubt the cost would be reduced if they were made in a batch. I am hoping to get the cost around 100 per set.

Let me know if there is still interest in a product like this.

This post is just to gauge interest at this time. Will start new thread if this turns out positively.
jlw is offline   Reply With Quote