View Single Post
Old 03-24-2014, 10:55 PM   #15
Gnarly Adventurer
Joined: Apr 2011
Oddometer: 237
When I first installed my Rekluse I had some slippage. I didn't notice that the outer most friction disk that rides against the pressure plate is actually different from the other friction disks (it doesn't look that different, but it's a different P/N). I had left this one out accidentally. I swapped it in to correct the problem, as well as measured the thickness of all my steels and used the thickest ones, and haven't any slippage since. Just throwing that out there since it didn't seem that clear from the Rekluse install video
BigTony is offline   Reply With Quote