View Single Post
Old 05-15-2003, 12:28 PM   #6
pilot OP
Slacker Moderator
 
pilot's Avatar
 
Joined: Dec 2002
Location: Kansas City
Oddometer: 31,285
remove insulation

You then have to remove the insulation from the inside of the can. I used a putty knife to scrape all the foam out starting about an inch down from the fiber gasket surface. I left the top inch in to support the gasket surface. I then painted the interior with truck bed liner in a can. Use plenty on the foam at the top.

Next is the latch and mount. I used eyebolts from Airparts for the lock hasp. Drill and cut out the tab to allow the eyebolt to pass through. The Happy Trails mount bolts on the back. Two more holes at the top for the hold on bolts and your through.

Attached Images
 
__________________
The other 10% are sociopaths , serial killers and KLR riders. You wont get much sympathy from them.
-Furious D

I first had sex at the age of 13. However, my butt hurt so bad I never did it again.
- Mista Vern

pilot screwed with this post 02-05-2010 at 08:20 AM
pilot is offline   Reply With Quote