View Single Post
Old 03-10-2006, 01:04 PM   #9
RedFlash
Go Cubs!
 
RedFlash's Avatar
 
Joined: Feb 2005
Location: Home of the Chicago Cubs!
Oddometer: 2,440
I just finished setting up my Emig clamps and stabilizer. I went with the under the bar mount. I noticed, on some of the photos, the tower holding the pin runs right up to the pivot arm of the stabilizer. Mine does not.

I also had to shim the pin up in its base to even engage the pivot arm. After seeing your photos, I think I have the wrong tower, even though the base is stamped, "LC-8". I'll give Paige and Gary a call to see if this is actually an LC-4 tower bolted onto an LC-8 pedestal.

Close, very close to being done...
RedFlash is offline   Reply With Quote