View Single Post
Old 06-12-2014, 06:51 PM   #28981
Skid plate tester
jgiacobbe's Avatar
Joined: May 2008
Location: Near Richmond VA
Oddometer: 2,374
Looked into it some. Material cost about $30 per 10 sqft. Some people out there have done some pretty cool bikes with it. Supposed to take some skill and patience to get it right. Complex shapes and concave curves are challenges. Look at videos for knifless tape and 3M 1080 film. Will probable order a couple samples just to get a feel for the material.
2009 Wee-Strom, 2002 VFR800, 2015 Ural cT
jgiacobbe is online now   Reply With Quote