Thread: Tank Guards
View Single Post
Old 08-05-2006, 10:47 AM   #72
Chrisbarnes1
Gnarly Adventurer
 
Joined: Dec 2005
Location: Market Deeping, Lincs UK
Oddometer: 434
tank protectors

Edge finishing--my last ones were on for about 8,000 miles--very little dirt etc...for sealing just use a small amout of silicon sealant as a fillet around the edge if you are bothered.

Ill try and post some more pics of the first set on my bike--next set half completed-and better quality-I will of course check fit on my plug tank before any shipment ---but getting perfect surface contact all the way round is not that easy---some warpage always occurs --especially if you remove from the mould too early--I made this mistake with the set on my bike--but it hardly shows.

Chris

Quote:
Originally Posted by overlandr
Great product. Perhaps you could post more detailed close up photos showing the edge finishing, outside and inside surface finishes and quality of fit to the tank to give people a better idea. Do you have a mould suitable for the 03 tanks as I think it differs from later tanks.
Chrisbarnes1 is offline   Reply With Quote