View Single Post
Old 09-03-2006, 05:22 PM   #6
jaydee1445 OP
Footpeg Crash Tester
 
jaydee1445's Avatar
 
Joined: Jul 2006
Location: high sided into the orange grove
Oddometer: 3,849
DOOH!! how did I post in thumpers?

The conector is tie wraped under inst. cluster. I belive it is rectancluar with four wires,brown, br/yellow, yellow, gr/red. Brown wire is ground but tested around 5v with my volt meter. Must have been reading sensor voltage???
I played around jumping the wires and the only function I could make work was cycling through the functions no reset The odometer cycles to next function when ground is applied then removed.
Hey tipover could you test the output of the tripmaster so we can figure how to do the other functions?
jaydee1445 is offline   Reply With Quote