oops, now for the suspension questions,
1) how do you guys torque the valves on the bottom of the forks to 25nm? i got one by slightly pulling down on the piston but the other fork just spins. i dont want to bend the piston trying to torque the valve.
2) when measuring the fork oil level, you measure 25mm from the top of the "4 holes", or roughly 35mm from the top of the outer tube?
3) when reinstalling the springs, what is the trick to getting the rebound cap back on. i remember this being a bitch the last time i changed the oil and dont remember how i got around it.
thanks, im having some issues and want to ride tomorrow so your help is appreciated. ive done this before but im frankly not to sure if i did the measurements correct. i wanted to stiffen the front so i added an additional 10mm on the last service. my problem is i think i measured from the top of the fork because when i checked the level today i was way over.