View Single Post
Old 10-25-2006, 06:16 AM   #1
boother OP
Gnarly Adventurer
 
Joined: Oct 2006
Location: Really, really flat Indiana
Oddometer: 227
Factory lowering a DR650

Has anyone performed the factory lowering themselves. Looking at the service manual, it does not look difficult. There are several special tools listed but the only one I think you would have to have is the "T-handle" to loosen the bolt down in the forks. Can anyone tell me what that tool really is? What is on the end of it? Square drive? Torx? PN 09940-34520. The rest of the "special tools" look like I can find an alternative.

Thanks
boother is offline   Reply With Quote