View Single Post
Old 11-27-2006, 07:39 PM   #4
bemiiten OP
League of Adventures
 
bemiiten's Avatar
 
Joined: Jul 2003
Location: Hamilton NJ.
Oddometer: 4,821
Managed to dig a little deeper tonight.
Bummer,It's not a bad u joint. To easy. Really don't think it's a clutch problem either. The sound stops when the clutch is pulled , but that means the input shaft unloads and stops spinning to. The video is a little deceiving. I was trying to recreate the sound by applying some rear brake in gear to simulate a load. The sound of the trans teeth rattling overshadow the cyclic rumble that is best heard in the last 25 seconds of the recording. This rumble is much worse under load and sounds like a bearing running with no lubrication. The sound has me convinced it's a trans shaft bearing. Beginning to wander if this leak has something to do with it. Input shaft bearing perhaps?
No choice now but to pull it off and open the tranny and have a look.

bemiiten screwed with this post 11-27-2006 at 07:45 PM
bemiiten is offline   Reply With Quote