View Single Post
Old 12-01-2006, 09:04 PM   #14
bemiiten OP
League of Adventures
 
bemiiten's Avatar
 
Joined: Jul 2003
Location: Hamilton NJ.
Oddometer: 4,835
My biggest fear was to go through all this and not be able to detect a bad bearing. All the rear bearings are turning smoothly and seem fine.
I start heating the front case.
And heat some more. and some more. It shows 205 but my hands are to oily to grab the camera.
Around 220 degrees the input and output shaft bearings are moving easy ready to drop out. The intermediate shaft will not budge. I go at it for a hour and a half with temps up around 230 with no luck. I'm getting frustrated so this round is lost.
Chinese takeout intermission.
bemiiten is offline   Reply With Quote