ADVrider - View Single Post

bemiiten · 12-28-2006, 08:17 PM

Next up is the output shaft. The bearings are removed along with the adjoining gears.

I follow the same procedure as before and wind up with similar results. About .006 shorter overall.

This should read zero , the bearings are the same size. ?? ?? One step I failed to take was making sure the old bearings were pressed fully home. It's in the manual ,but I neglected this step. It's the only possibility I can think of. I'm very confident the bearings are the exact same size.

12-28-2006, 08:17 PM	#49
bemiiten ^OP SWM Adventuer Joined: Jul 2003 Location: Hamilton NJ. Oddometer: 4,153	Next up is the output shaft. The bearings are removed along with the adjoining gears. I follow the same procedure as before and wind up with similar results. About .006 shorter overall. This should read zero , the bearings are the same size. ?? ?? One step I failed to take was making sure the old bearings were pressed fully home. It's in the manual ,but I neglected this step. It's the only possibility I can think of. I'm very confident the bearings are the exact same size. bemiiten screwed with this post 01-22-2007 at 05:55 PM