View Single Post
Old 01-20-2007, 12:47 PM   #36
Big bike friendly
KTMSER's Avatar
Joined: Nov 2006
Location: Six feet from hell Phoenix AZ
Oddometer: 2,758
Originally Posted by gefr
I just think it is good to keep my clutch well lubricated without affecting too much the oil pressure in the circuit. So I let it be at 0.5mm.

Is this the size the stock jet is 0.5mm? or did you drill to this size? I removed mine today. Before removing said jet I could see something shiny blocking it a small piece of metal debris. Getting it out of the hole with a shop vac reduced to a 3/8 hose it pulled right out. That is sure a small hole in the jet it wont take much to plug it. The question is to drill or not to drill any ideas?
Originally Posted by WaterWheel View Post
The things I would do with that old broad would make a seasoned porn producer puke.
KTMSER is offline   Reply With Quote