View Single Post
Old 02-25-2007, 04:35 AM   #11
Boon Booni
Red Clay Halo
 
Boon Booni's Avatar
 
Joined: Aug 2003
Location: Richmond, Va
Oddometer: 12,805
Quote:
Originally Posted by katbeanz
I have a bunch of small conveyor rolls that when the bearing fails you end up with the outer race still in there.
What I do, and use this method at your own risk, is run a bead of weld on the inside of it, it will work with mig but works best stick welding.
As the weld cools it shrinks the race along with it and they normally just fall out with a tap on the side of the workbench.

Do you need to run a bead all the way around, or just a couple of inches?
__________________
A little nonsense now and then is relished by the wisest men.

You can be Han Solo, and I can be another Han Solo...
Boon Booni is offline   Reply With Quote