View Single Post
Old 03-15-2007, 06:43 PM   #36
Cogswell OP
Spudly Adventurer
 
Cogswell's Avatar
 
Joined: Jan 2005
Location: Riding with my pal Richard Cranium
Oddometer: 4,064
Long overdue update.

Ok, I know it's been a while but work has been on the front burner for a while. The project has not been ignored. Most engine machine work, cleaning, and assembly has been done. I still have a couple of items to take to powder coat, bottom of the air box, and probably the engine front cover. It's really rough and I'll either try to match it to engine color or have them do it in black.













I have the wiring harness run and everything plugged back in at the fuse panel in the headlamp. Rear brakes are on and bled, front brakes have been a bit of a pain. When I got the bike there was an issue with the right side caliper inner half interfering with the rotor. I think I have that sorted by shimming the rotor out from the wheel.
Body work painting is going to be started soon, I will probably meet with the painter this weekend. Other than that it's a little fitting here and a little more cleaning there, and a few oops I forgot to order that too's

Mike
__________________
Cogswell Rides To Big Bend
See my airhead project here
Time Warp Vintage Motorcycle Club
The good thing is, your damn motor can't read. If it says oil on the container, it's pretty much OK to dump in there.... ED.

Cogswell screwed with this post 03-06-2011 at 10:44 AM
Cogswell is offline   Reply With Quote