View Single Post
Old 03-21-2007, 07:10 PM   #65
bemiiten OP
League of Adventures
 
bemiiten's Avatar
 
Joined: Jul 2003
Location: Hamilton NJ.
Oddometer: 4,875
Quote:
Originally Posted by AntonLargiader

Again, none of the numbers mean anything. Measure your parts as if it were an Airhead tranny.
The only way I could think of to measure the 6 speeds bores is with adjustable mock transmission shafts that could be used in conjunction with plasiguage to arrive at the ideal number. The manual calls for no more than .002 deviation from a end play value it dose not give.
With no current means of manufacturing some homemade mock shafts that would be accurate at those tolerances, I decided that if the bearings are exactly the same as what came out , then that is my better bet then to base shim size on inaccurate information.
bemiiten is offline   Reply With Quote