View Single Post
Old 04-19-2007, 06:28 PM   #167
Professor Fate
Hand crafted
Professor Fate's Avatar
Joined: Aug 2003
Location: North , Id
Oddometer: 126
Originally Posted by zorba75482
Not sure what the Yokes are, can you enlighten me ? I marked the housing and cover before removal as per instructions in Clymer manual.

I guess you did'nt take the whole drive unit off yet. but if you did there is a ujoint on each end of the driveshaft with a slipjoint at the rear where you would take the drive unit off the swing arm. When you put that slip joint back together the ends should match up like in this expertly drawn illustration.
Attached Images
I've been through more hard times than the jews and Charlie Brown put together--Homer Simpson
Professor Fate is offline   Reply With Quote