View Single Post
Old 05-04-2007, 08:05 AM   #84
Ride Wet!
airansun's Avatar
Joined: Jun 2005
Location: NorCal
Oddometer: 307
Originally Posted by dlew
has anyone fit one of ernie's engine plates with a remus header? mine doesn't want to fit.

i assumed the remus headers followed the same path as the oem pipes but it appears they are wider.

I fit my Ernie's plate on my R1200GS, which has a full Remus setup. While the plate sides come close to the header pipes, they don't touch. At first, I thought I would have a problem, but it bolted up okay with no modification.

My only regret is that the front plate lip doesn't come up higher - I no longer have a cross-over pipe there! Due to the welds, I am not inclined to try to bend that front lip upwards.

Good luck!
'06 HP2
'05 R1200GS
airansun is offline   Reply With Quote