View Single Post
Old 06-07-2007, 08:03 AM   #72
wickedsprint
Banned
 
Joined: Oct 2004
Location: USA
Oddometer: 2,386
Quote:
Originally Posted by gdeiss
Speaking of handlebars, those on my '97 DR200Se are very slightly bent and new ones are pretty cheap as long as I stay away from interesting alloys. If I'm replacing I'd want something that was a little taller, but I don't want to have to do anything to cables, etc. Any recommendations? How tough a job is it?
We found some aftermarket bars at the dealer, I forget what they were for, but they went right on, howevever the stock throttle cable housing has a plastic tiny nub that fits into a hole on the stock DR200 handlebars, just grind this piece off, it will be blatantly obvious if you try and tighten the throttle housing down on the new bars and you'll see right away what you have to file down. No biggie. The DR200 uses the common bar size, so just find an aftermarket one that is pretty close, I think they were renthal.
wickedsprint is offline   Reply With Quote