View Single Post
Old 11-20-2007, 11:24 PM   #11
Dotbond OP
Africa, Africa
 
Dotbond's Avatar
 
Joined: Jun 2006
Location: Dunedin. New Zealand
Oddometer: 732
[quote/]#4 Use the crankshaft locking bolt to lock the shaft you can then loosen and remove the sprocket retaining bolt. Pry the bearing circlip up out of its groove. You then can tilt the cap bearing end of the camshaft up and slide the shaft out of the sprocket. Once clear of the sprocket the shaft, bearing and circlip can be lifted out together and a dowel can be put in the sprocket to hold it in place....[/quote]

Looks like i have a standard length bolt M8x16mm and 1mm thick washer according to the info about the bolt in the manual and i need a special tool.
I suppose a longer bolt would be the go. An ideas on the length required?
__________________
2012 KTM 690 R
2010 KTM 990 R (Sold)

2008 N.Z.Yamaha Safari: http://www.advrider.com/forums/showthread.php?t=306905
2007 N.Z.Adventures Safari: http://www.advrider.com/forums/showthread.php?t=201557
Dotbond is offline   Reply With Quote