View Single Post
Old 04-25-2008, 05:51 AM   #1249
motoreiter
Beastly Adventurer
 
Joined: Oct 2007
Location: Moscow, Russia
Oddometer: 1,136
Quote:
Originally Posted by adamr
If youre' talking about replacing the entire ring antenna, I'm pretty sure it's installed with one-way security screws that need to be drilled out. Afterwards, some people install non-security screws for easy replacement.
As I understand it, you only need to undo the security screws if you intend to remove the bad EWS and replace it with the new EWS. This is a permanent fix.

On the otherhand, for a temporary fix, you only need a Torx 10 wrench: keep the bad EWS in place, unplug the connector, and plug it into the new EWS, which you zip-tie near the ignitiion...

Is that correct?
motoreiter is offline   Reply With Quote