View Single Post
Old 05-03-2008, 11:02 AM   #24
Tim Cullis
Partially heighted
 
Tim Cullis's Avatar
 
Joined: Dec 2004
Location: London, Granada Altiplano and Morocco
Oddometer: 273
Bypass wiring

I'm in Morocco for the next few weeks and my bike isn't going to be near a dealer for some time, so I've done a controller bypass to the existing wiring loom. OK, it's not neat but this is something the dealer is going to have to sort out under warranty when I'm back in the UK.

The connector running into the TOP of controller has three wires. Bare the right-hand and middle ones (and try not to slash the other in half as I did). Make an 'eye' in each of the cables to accept the splice.



Cut the two cables with terminator block off the BOTTOM of the duff controller and splice
- the BLUE bottom cable into the BROWN top one
- the YELLOW bottom cable into the BLUE/GREEN top one.



Cover liberally with insulating tape, plug the terminator block into its position and start engine!

Tim
__________________
Access the Morocco GS Knowledgebase

Tim Cullis screwed with this post 07-25-2008 at 01:58 AM
Tim Cullis is offline   Reply With Quote