Originally Posted by itsatdm
The 800 fasteners are just about all Torx vs hex or Allenhead.
So to work on the bike you need the following:
Torx T10 left control housing
T20 throttle assembly
T25 fairings, control, body work
T30 muffler mount, signals, motor chassis, rotor
T40 triple clamp, brake pivot, rear rotor, brake line
T45 body, exhaust mount, fork axle pinch bolts, controls
T55 Bar Ends
E10 handlebar clamps
E12 Front Caliper brakes
13mm Chain tension sprocket
17 mm Front Axle
22mm Rear axle
24mm Drain plug.
Add to this...
E8 for the external torx on the gear shifter lever.
19mm hex bit for the front axle.
22mm hex bit for the rear axle.