Thread: XR650R Thread!
View Single Post
Old 12-09-2008, 10:47 AM   #80
GISkev
wwfsmd?
 
GISkev's Avatar
 
Joined: Dec 2007
Location: UT
Oddometer: 1,685
BRP valve adjustment

The book says to pull your left side case and spin to Top Dead Center with a wrench to line the "T" up with the "notch", but there's a nice little hex plug that you can take out to see the "T"... is it ok to put the bike up on a stand and instead of spinning to TDC with a wrench, just spin the wheel in gear to line up and then adjust the valves? Seems reasonable (and a lot easier) than pulling the side cover off.
__________________
Merge w the traffic, but don't go w the flow!

--GoProHero Helmet Cam!--http://www.youtube.com/results?searc...y=utahkev&aq=f
5 deserts:http://advrider.com/forums/showthrea...3#post15462553
KTM 520 (plated), Wee-Strom (commuter bike)
GISkev is offline   Reply With Quote