Thread: Flexing my ABS
View Single Post
Old 12-26-2008, 03:02 AM   #41
KTM Pilot
Gnarly Adventurer
KTM Pilot's Avatar
Joined: May 2005
Location: Perth, Australia
Oddometer: 439
Thumb ABS disconnect

I've just finished the Triwi method (wired to both rear wires = short). Works a treat!

Only thing I did different was to use my high beam flasher button (you know the one you flash with your left index finger?).
Disconnected the white and green with black stripe wires from the connecting block behind the dash(these go to the switch), wired them to some figure 8 wire that goes to the abs wires under the seat. Total cost, well nothing except the wire that I already had.

Flick the flasher switch once, and the abs it off until I next restart.
Smugmug $5 discount coupon # 2ucrtCWwf7D7A
KTM Pilot is offline   Reply With Quote