Thread: LC4 rocker arms
View Single Post
Old 01-04-2009, 12:58 PM   #11
gunnerbuck
Island Hopper
 
gunnerbuck's Avatar
 
Joined: Nov 2005
Location: N.V.I, B.C.
Oddometer: 3,598
Tseta,
You do not need to remove the engine to shim out too much rocker play.... You need only to remove the valve cover and these instructions will help guide you: http://www.advrider.com/forums/showthread.php?t=112127 The shafts and rockers are contained within this cover so it is easy to work on...


With the cover off, the rocker shaft will then slide out as the cover mounting bolts are what hold them in place.... What you will need is a selection of the shims so you can swap them out to obtain the correct play...

Good luck...
David..

gunnerbuck screwed with this post 01-04-2009 at 01:05 PM
gunnerbuck is offline   Reply With Quote