Does anyone have the bar end weight hardware that they don't want? I found the weight, but lost the screw and expander stuff in a steep hill get off.
I have an '01 E model(new to me).I put on the seat concepts cover as well as the rack they sell.As my bike has no sub frame,does anybody know how much my rack can carry?Thanks.
I prefiltered my atv airbox lid with a piece of old cut up air filter and hot glue. I didnt notice any jetting changes required. I will be doing the 3x3 on my DRZ airbox in the near future as well. It really lengthens the air filter life and service intervals.
When purchasing a kick start for an s model, do you have to buy the kit or can you just order e model parts?
A few pics from today's morning ride, was 38 degrees when i left the house at 9, i know it aint shit to you guys from other states, but out here anything below 40 is considered a state emergency, lol
In the 90's I had a DT200R that had been done up by a pro, it also had a make shift sponge foam pre filter over the opening cut in the air box, somehow I am going to rig one up for the DRZ. Looking at it yesterday I was thinking of bending up a bit of 6mm wire into a frame to hold my pool filter sock.
Best and cheaper to get the kit. Here is a link that may help on the install. https://mr-cob.smugmug.com/gallery/136763#!i=4997029&k=CgVqznJ
Pack on page 743, the image below was posted..... Does anyone have a set of these racks? How are they holding up?
I have lots of douchebags wanna be thugs that live around me, even tho its garaged, i still lock it up
After spending too amny hours searching for the Mukini Flaot Valve part# for my 2002 DRZ400S, I ordered the wrong part from Thumper Talk Parts Store. Anyone have the part number for my Mikuni 29FB carb? I've got the leaking valve problem. probably the "O" ring, but might as well replace the whole assembly. Thanks in advance!! Lee Ullmann Casa grande,AZ
That whole assembly is like 60+ bucks, i just replaced my o-ring and it fixed my leak right away, no need to buy the whole assembly, just take your o-ring to a auto parts store and match it up, they did not even charge me for it.
I had looked at those, but was concerned that the rack only had 2 mounting points; therefore not much to stop it twisting under the load... plus they are too low and too far forward for the panniers I have. In July (our winter), I'll need to carry my Caribou (Pelican) cases for a very remote, rough, long & unsupported ride. I have made up a rack that works, but I know it can be made lighter and a bit narrower than what I have... I was just looking at easily adaptable options that could go the distance. I'm looking at approx 10-14kg per side for the pannier & contents (probably less, but I always like to allow for more). And no, I'm not changing from the Caribou luggage, It was chosen for a reason (several of them actually).
Good choice on the luggage, saw an 1150 Bmer dropped on those, it only bent the mount a little, no more than a scratch or two on the side bag.
I just replaced my o ring today.... Ended up buying a pack of doorman Vinton orings from discount auto for $8 and it had the size inside. Sent from my Nexus 7 using Tapatalk HD
A few pics from a recent blast on the DRZ400 Full ride report and more pics here Full ride report and more pics here
