Rallye navigation bracket photo thread

http://www.cmsnl.com/honda-cr500r-1997-australia_model2881/rubber-silencer_18334ml3680/ maybe?

The fairing will be made once the tower is in place but it will be very close to the 690 rallye part!

Niiiiiiiice

If you are using the Mikuni BST a 03 Ktm 625 sxc uses such a thing..
numbers 93-94-95

<table bgcolor="yellow" border="1" cellpadding="3" cellspacing="0" width="460"><tbody><tr><td align="right">Part Number:</td> <td align="left" bgcolor="white">0912060303</td> </tr> <tr> <td align="right">Description:</td> <td align="left" bgcolor="white">AH SCREW DIN0912-M 6X30</td></tr></tbody></table>


<table bgcolor="yellow" border="1" cellpadding="3" cellspacing="0" width="460"><tbody><tr><td align="right">Part Number:</td> <td align="left" bgcolor="white">58302095251</td> </tr> <tr> <td align="right">Description:</td> <td align="left" bgcolor="white">SLEEVE FOR CHOKE CABLE</td></tr></tbody></table>

<table bgcolor="yellow" border="1" cellpadding="3" cellspacing="0" width="460"><tbody><tr><td align="right">Part Number:</td> <td align="left" bgcolor="white">58302095400</td> </tr> <tr> <td align="right">Description:</td> <td align="left" bgcolor="white">CKOKE CABLE BST 40 L=242MM '00</td></tr></tbody></table>

That's exactly what I have on the 640.

@Antal: English word is grommet, in German: Gummidurchführungstülle
Can get them here at Conrad. I have various types to mount tripmasters on to 3mm plates with here, let me know if you need any!

Thanks for all the responses! Will check!

Hi to all:
My name is Juan Carlos, from Spain. In 60 days I will be racing the IRC2013.
http://www.intercontinentalrally.com/
I want to share with you my little esperience....
My bike is in rally progress now.
I show it to you:



This a cheap way to race.



Well, I add more pictures soon.

Gaasssss.

So I'm finally getting around to making a proper fairing for my nav tower, at this stage it's just a plug made of MDF. It will be vacuum bagged carbon/kevlar eventually.

Darth Vader has arrived

you might consider giving that top edge a small amount of curl so that if you do an ender over the bars it has less knifing potential.

I did finally get around to watching star wars episode 3 a few weeks ago, maybe it rubbed off on me.

Thanks for the tip, I think I'll add a bit of a lip the whole way round.

Used some HDPE cutting boards to mock up my brackets. Glad I did. I have interference on both sides, brake line on right side and a mounting bolt on the left side.

On the rally bikes we build, we re-route the brake lines so that all the moving portion is between the caliper and the lower triple clamp. Everything above the lower triple is fixed to the triple and bars to avoid interference. We attach the line to the triple using rubber-lined loop clamps.

Here's Kevin doing that on his 2013 Dakar bike (pic courtesy RMK).



Dave

on the KTM's there are 2 - 6mm holes that position it perfect.
This is a pic from my installation instructions.

you mean the two "P" clips on the bottom triple?

Yes. They are called loop clamps.

Dave

"Oooo a 'garage.' La dee da Mr. French man."
"What do you call it?"
"A car hole!"

Etch Touratech or Acerbis on each loop and you can charge $20 for them