Introducing our Panel Mount voltage, temperature and time meter This is the auto function mode <iframe src="http://www.youtube.com/embed/hZmJvzlToEE" allowfullscreen="" frameborder="0" height="315" width="560"></iframe> From our website: Waterproof digital panel mount Voltage, Time and temperature meter. Manual or automatic selection of function: manual selection using push button or auto cycle shows each function for 5 seconds. DC 4-30v volts 12 hour clock Temperature (F) - 256<sup>0</sup> F maximum, 1 meter long thermocouple with stainless steel probe. Sunlight viewable, anti-glare screen, bright red characters Two button switch panel controls : 3.5" (89mm) leads Three wire connection: Red power, Green voltage signal, Black ground. 5" (128mm) length leads. Wiring allows the voltmeter to measure a different source than what is powering the meter. Connect power and ground to a switched connection and the meter will turn on with your vehicle. Panel cutout size (width X height)-1.5" X .83" or 38mm X 21mm Flange dimensions (width x height)- 1.6" X .95" or 41mm X 24mm Depth is .6" or 15mm from back of flange Overall depth is .7" or 18mm from front of flange
The temp is for eng. coolant ? A nice ambient temp would be nice. I haven't seen one yet that I'm thrilled about.
Well, nice to have one gauge to replace three. Even though there's a fair amount of room behing that dual sport fairing! Just ordered one.
Since the voltage signal is the same as the source power in this case is there any reason those two terminals couldn't be jumped and have a single wire coming in?
The meter has seperate signal and power wires. The benefit is you can connect the power wire to a switched (on/off with bike) and the meter comes on or turns off with the bike. You can connect both wires to the same source. Yes, the meter has a small 2 button sub-panel.
