Go Back   ADVrider > Gear > Vendors
User Name
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 04-27-2011, 05:35 AM   #11
pottsygs's Avatar
Joined: Oct 2009
Oddometer: 3
Having installed my new fairing I wanted to share a few comments, thoughts and tips.

Is it any good? - The short answer is yes, however there are some issues surrounding the installation and build quality.
  • The lighting is fantastic, even without an HID upgrade
  • The screen works well, allowing higher speeds for longer periods
  • The dashboard placement for GPS is perfect
  • Internal space is available for an Autocom or similar intercom

Installation - Relatively straightforward, it took me about 2.5 hours. Care needs to be taken in re-routing the original loom and relays as well as making sure the long metal light adjusters are not going to rub any insulation away. The instructions provided with the kit are adequate but flawed in these 2 areas:
  • I would suggest that you cut the plug off your lights and fit it to the fairing’s loom, rather than follow the instructions and cut the plug from the bike - if you want to re-fit the old unit (maybe when you sell the bike) it is possible to buy the short lighting loom from a KTM dealer and this method leaves the front section of the fairing easy to unplug for removal.
  • The kit includes 2 allen type cap screws to fit the fairing bottom to your lower triple clamp and the instructions tell you to use these rather than the originals. This is wrong for 2 reasons - small screw heads without washers will cut through the composite and no access is available for a ball ended allen driver. I suggest using the original bolts which have built in washers to spread the load and allow access with a combination spanner. If you use the ring end and then alternate the direction of the open end you can eventually do these fasteners up but this is a bad design and I am going to make a QD alloy plate for the bottom of mine.

Build / fit – Given the price of the unit (and the fact that it is marketed as ready to use) this was disappointing but can be fixed:
  • When I first rode with the unit fitted there was vibration at low revs because the profile of the rear dashboard does not accurately follow the inside of the front fairing panel. The bottom corners of the dash needed to be reduced by around 4mm to fix this.
  • With this sorted I rode again but found the unit bounces a lot on bumps, even quite minor ones on the road, and when this happens the front and rear mouldings collide loudly. I have slit and fitted some thick walled fuel hose to the dash panel’s lower edges and this prevents the banging but in the longer term, especially for off road use, the 2 halves need to be joined with a rubber block screwed to each side. I will make something up myself, unless Britannia fairings respond to this issue themselves.

Summary – I would recommend the unit to anyone who is prepared to do the work needed to make it satisfactory but not to someone who wants an out of the box solution.

Note to Britannia - please get in touch about the required improvements -
pottsygs is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

Times are GMT -7.   It's 11:49 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015